DVDO Quick
6R
6x2 4K Ultra HD HDMI Switcher
DVDO-UG-1001-B.01 © 2014 Silicon Image, All rights reserved 9
Rear Panel
See the Updating Firmware section on page 23 for details. This button is held
during power-up to start the firmware update process from an attached USB
flash drive.
Primarily used for updating firmware, and also supplies 5 V @ up to 1 A for
accessories.
Allows control of Quick
6R
by external control systems.
MAIN output is always active, AUX output depends on OSD setting; The two
available modes are Mirror and AVR.
Coax and optical: Whenever the audio stream permits, audio is extracted from
the active input and sent to the S/PDIF outputs.
Input 1 and Input 6 are each capable of connecting to an HDMI device or an
MHL mobile device using only a passive cable. Each of these ports can supply
up to 900 mA for charging the mobile device.
Input #6 is the only port that will accept the Roku streaming stick
Connections
AVR via AUX HDMI and AVR via S/PIDF Modes
In these AVR connection modes, Quick
6R
becomes the primary HDMI switch and control center for a home
theater. Connection to an existing Audio-Video Receiver (AVR) is accomplished using either HDMI or
S/PDIF (for older AVRs with no HDMI). If the AVR has an HDMI input, this is the preferred connection
because it provides the best overall experience. With either connection, the AVR is always left on that input
and all switching is done with Quick
6R
.
Komentarze do niniejszej Instrukcji